Advanced Operational Features
6-22 41-001343-02 REV05 – 07.2014
6. Select EAP-MD5 to configure the phone to use MD5 authentication;
or
Select EAP-TLS to configure the phone to use TLS authentication.
Note:
The 802.1x Protocol is disabled by default. If you select EAP-TLS authentication, you must use the configuration files or the Aastra Web UI to
configure the certificates and private key for the phone.
7. Press Done (on 8 and 11-Line LCD phones)
or
Press Set (on 3-Line LCD phones).
8. To configure MD5, select EAP-MD5 Settings.
9. Select Identity.
10. Enter the identity or username used for authenticating the phone.
11. Use the keys as applicable while entering the username; then press Done (8 and 11-Line LCD phones).
or
Press Set (3-Line LCD phones).
12. Enter the password used for authenticating the phone.
13. Use the keys as applicable while entering the password; then press Done (8 and 11-Line LCD phones).
or
Press Set (3-Line LCD phones.
14.
Press the key to save your settings and exit from the IP Phone UI.
IP Phone UI
To Next Page
Loading...
