Troubleshooting
41-001343-02 REV05 – 07.2014 9-3
Setting Values for the Module/Debug Levels
There are 6 debug levels for the modules. Each debug level has a value you can use to turn individual levels ON and OFF.
The following table identifies these debug levels and their values. The value of “1” (fatal errors) is the default setting for all
modules.
Example 1
To turn two or more debug levels on at the same time, you add the value associated with each level. For example,
Fatal Errors + Errors + Warnings = 1 + 2 + 4 = 7
l
og module linemgr: 7
log module user interface: 7
log module sip: 7
In the above example, fatal errors, general errors, and warnings are logged for the line manager, user interface, and SIP call
control modules.
Example 2
Functions and Info = 16 + 32 = 48
log module dis: 48
log module net: 48
log module snd: 48
In the above example, functions and general information are logged for the display drivers, network, and sound modules.
IND (Indicator module) log module ind
KBD (Keyboard module) log module kbd
NET (Network module) log module net
PROVIS (Provisioning module) log module provis
RTPT (Realtime Transport module) log module rtpt
SND (Sound module) log module snd
PROF (Profiler module) log module prof
XML (Extension Markup Language) log module xml
STUN (Simple Traversal of User Datagram Protocol (UDP) through Network
Address Translation (NAT)
log module stun
LLDP (Link Layer Discovery Protocol) log module lldp
BLUETOOTH (6739i only) log module bluetooth
Debug Level Value
Fatal Errors 1 (default)
Errors 2
Warnings 4
Init 8
Functions 16
Info 32
All debug levels OFF 0
All Debug Levels ON 65535
Aastra Web UI Parameters Configuration File Parameters
To Next Page
Loading...
