ABB ACS860 - Page 293

Parameters 293
96.03 Access levels
active
Shows which access levels have been activated by pass
codes entered into parameter 96.02 Pass code.
This parameter is read-only.
0001h
0000h…FFFFh Active access levels. -
96.04 Macro select Selects the application macro. See chapter Application
macros (page 79) for more information.
After a selection is made, the parameter reverts automatically
to Done.
Note: This parameter cannot be changed while the drive is
running.
Done
Done Macro selection complete; normal operation. 0
Factory Factory macro (see page 80). 1
Hand/Auto Hand/Auto macro (see page 82). 2
T-CTRL Torque control macro (see page 84). 4
Sequence control Sequential control macro (see page 86). 5
96.05 Macro active Shows which application macro is currently selected. See
chapter Application macros (page 79) for more information.
To change the macro, use parameter 96.04 Macro select.
Factory
Factory Factory macro (see page 80). 1
Hand/Auto Hand/Auto macro (see page 82). 2
T-CTRL Torque control macro (see page 84). 4
Sequence control Sequential control macro (see page 86). 5
96.06 Parameter restore Restores the original settings of the control program, ie.
parameter default values.
Note: This parameter cannot be changed while the drive is
running.
Done
Done Restoring is completed. 0
No. Name/Value Description Def/FbEq16
Bit Name
0 End user
1Service
2 Advanced programmer
3…10 Reserved
11 OEM access level 1
12 OEM access level 2
13 OEM access level 3
14 Parameter lock
15 Reserved