10-16 Chapter 10: Status Messages, Troubleshooting 42/24-10 EN Rev. 9
Status Messages, continued
No. Text O E M F Reaction /Remark
529 Calibration stopped because
no raw measurement values
were found.
x x
530 Calibration stopped because
the pressure switch did not
detect any calibration gas.
x x
531 Automatic validation started. For information
532 Automatic validation ended. For information
533
utomatic validation externally
interrupted.
For information
534 Automatic validation in
progress.
x For information, not logged
535 Automatic validation
successful for:
536 Automatic validation out of
limits for:
537 Automatic validation out of
limits for:
x
User-Configured Messages
800 An external error occurred
during:
x x
801 A user-defined error occurred
during:
x x
802 A user-defined maintenance
requirement occurred during:
x
803 A user-defined maintenance
mode event occurred during:
x
These Message Generator function block default texts
are supplemented with the text prepared during function
block configuration.
Miscellaneous Messages
1000 This function block has an
error:
x x Supplemented with a reference to the function block type.
1001 Condensate penetration. Overall message for guiding reaction to condensate
penetration; not logged
1002 Flow rate excessive at this
point.
x x Currently not used
1003 Flow rate inadequate at this
point.
x x Currently not used
Continued on next page
To Next Page
Loading...
