ControlMaster CM10, CM30 and CM50
Universal process controllers,
1
/8,
1
/4 and
1
/2 DIN 7 Advanced Level
60 IM/CM/S–EN Rev. R
…Control / …Loop 1 Output
Slew Rate The (output) Slew Rate restricts the maximum rate of change of the
control output.
Function Selects if the output Slew Rate function is enabled and when it applies.
Off
Up and Down
The Slew Rate applies to increasing and decreasing output values.
Up
The Slew Rate applies to increasing output values.
Down
The Slew Rate applies to decreasing output values only.
Rate The maximum rate of change of the control output (as % / s).
Disable Source The (level-triggered) source required to disable Slew Rate
control of the output. This source is level-triggered.
To Next Page
Loading...
