ABB FSM4000 - Product Identification; Identification of the Device Design

10 FSM4000 ELECTROMAGNETIC FLOWMETER | OI/FSM4000-EN REV. E
3 Product identification
Position of the name plate / factory plate
The factory tag or name plate can be found in the following
places on the meter housing:
1
Name plate sensor
2
Factory plate sensor
3
Name plate transmitter
Figure 3: Plate positions
Identification of the device design
1. Identifying the model:
The model number of the flowmeter primary or transmitter
(see nos. 1 or 2 in the description of the model plates) can be
found on the model plate. The electrical connection for the
respective model can be found in the chapter ‘Electrical
connections’. Technical data, material load curves, etc.,
appear sorted by model in the chapter ‘Specification’.
2. Identifying the transmitter design:
The transmitter design can be identified from the name plate
on the transmitter housing.
3. Identifying the software version:
The software version can be displayed when the transmitter
is switched on.
Note
Products that are marked with the adjacent symbol
may
not be disposed of as unsorted municipal waste
(domestic waste).
They should be disposed of through separate
collection of electric and electronic devices.
Name plate
Note
The name plates displayed are examples. The device
identification plates affixed to the device can differ from this
representation.
Sensor
1
Model no.
2
CE mark (EG conformity)
3
Order number
4
Meter tube lining /
electrode material
5
Nominal diameter / Nominal
pressure
6
Max. measuring medium
temperature
7
IP rating of the housing
8
Max. flow rate at v = 10 m/s
9
Power consumption
0
Phase relationship between signal
and reference voltages
k
Reference voltage
l
Cs calibration factor span
m
Cz calibration factor zero point
Figure 4: Name plate sensor
Transmitter
1
CE mark (EG conformity)
2
Model no.
3
Order number
4
Power supply - voltage
range / frequency
5
Power consumption transmitter
and sensor
6
Design according to order
with/without HART® protocol or
PROFIBUS PA® or FOUNDATION
Fieldbus®
7
Design according to order active
(24 V pulse) or passive
(optoelectronic coupler) (Switch
to active or passive) can be made
on site)
Figure 5: Name plate transmitter S4