ABB FSM4000 - Page 71

FSM4000 ELECTROMAGNETIC FLOWMETER | OI/FSM4000-EN REV. E 71
Submenu / parameter Value range Remark
Display 1st line
FB TOT1 Total. Displays the total value for the totalizer block.
The displayed unit is UNIT_TOTAL.
FB TOT1 Status. Displays the current mode of the particular
block and the status of the output variables (Total. Status). The
substatus is displayed after the status, if applicable. Example:
BAD 3 means status is BAD, substatus 3 = device failure.
FB TOT2 Total. Displays the total value for the totalizer block.
The displayed unit is UNIT_TOTAL.
FB TOT2 Status. Displays the current mode of the particular
block and the status of the output variables (Total. Status). The
substatus is displayed after the status, if applicable. Example:
BAD 3 means status is BAD, substatus 3 = device failure.
For information about the numeric code, refer to the interface
documentation.
TBT → Value
Display 1st line Devices with FOUNDATION Fieldbus, in addition to the following
options: Flow rate in percentage, Physical unit, in m/s, Bar graph,
Totalizer, Totalizer→ F, Totalizer ← R, Totalizer diff., Detector
empty tube; have additional options: FF address, this is
displayed hexadecimal.
TBT → Status
Display 1st line
Displays the value or status of the flowrate (TB Primary_Value,
Index 14).
TB VolFlowValue
Display 1st line Displays the value or status of the totalizer →Forward (TB
Secondary_Value, Index 28).
TB Total → F Value.
Display 1st line
Displays the value or status of the Totalizer ← R (TB Third_Value,
Index 30).
TB Total ← R Value.