7.6 Standard toolkit
General
All service (repairs, maintenance, and installation) procedures contains lists of
tools required to perform the specified activity.
All special tools required are listed directly in the procedures while all the tools
that are considered standard are gathered in the standard toolkit and defined in
the following table.
This way, the tools required are the sum of the standard toolkit and any tools listed
in the instruction.
Contents, standard toolkit
ToolQty
Socket head cap 2.5-17 mm1
Torque wrench 0.5-10 Nm1
Small screwdriver1
Plastic mallet1
Ratchet head for torque wrench 1/21
Socket head cap no. 2.5, socket 1/2" bit L 110 mm1
Small cutting plier1
T-handle with ball head1
260 Product manual - IRB 120
3HAC035728-001 Revision: N
© Copyright 2009-2017 ABB. All rights reserved.
7 Reference information
7.6 Standard toolkit
To Next Page
Loading...
