ABB IRB 2000 - Page 187

Default value
ESAB-I/O not reserved.
Menu selection
DEFINE^ Reserve ESAB I/O.
UNDEF = No ESAB I/O reserved.
BREAK = No change required.
Parameter
If ESAB I/O is reserved, BOARD POSITION 3 is used where digital inputs 9-16
and digital outputs 9-16 are reserved as ESAB I/O.
Note
See also section 3.10.5
Guide text
BOARD POSITION =
5.2.4.11
PANEL, Reservation panel I/O
Description
Menu selection is defined if digitla inputs 1-8 and digital outputs 1-8 or a digital
I/O board in the control cabinet are to be reserved for use as panel I/O.
Menu
IN/OUT + I/O USE + PANEL
Information text
PRESENT VALUE = NOT DEFINED
= Panel I/O not reserved.
PRESENT VALUE = DEFINED
= Panel I/O reserved.
Default value
Panel I/O not reserved.
Menu selection
DEFINE= Reserve panel I/O
UNDEF = No panel I/O reserved
BREAK = No change required.
Parameter
If panel I/O is reserved, the parameter BOARD POSITION is used to define which
board position 1-6 that is reserved for panel I/O.
Menu
Resulting question after DEFINE above.
Guide text
BOARD POSITION =
Def. range
1-6 corresponding to board position 1-6.
Note: It is recommended to reserve panel I/O on the last I/O board, and to define
the same I/O board for system I/O, if used.
INSTALLATION
5:23