6 Reference information
6.8. Special tools
3HAC022032-001 Revision: E278
© Copyright 2004-2008 ABB. All rights reserved.
Lifting tool
The table below specifies the lifting tools required during several of the service procedures.
The tools may be ordered separately and are also specified directly in concerned instructions
in the Product manual, procedures.
Lifting tools
The table below specifies the lifting tools required during several of the service procedures.
The tools may be ordered separately and are also specified directly in concerned instructions
in the Product manual, procedures.
Description Qty Art. no.
Lifting tool 3HAC 026597-001
Hoisting block
Lifting chain (used together with the hoisting
block)
Support, base and gear axis 1 3HAC15535-1
Lifting tool, gearbox axis 1 3HAC 15556-1
Lifting eye (used together with lifting tool
3HAC 15556-1)
3HAC 025333-005
Lifting tool, gearbox 3HAC 025214-001
Guide pins, M12x130 3HAC 022637-001
Guide pins, M16x
Lifting eye, M16 3HAC 14457-1
Lifting eye, M20
Crank
Description Qty Article no.
Lifting tool, tilt house 3HAC 023154-001
Lifting tool, lower arm + balancing weight 3HAC 8446-1
Lifting tool, lower arm 3HAC 8445-1
Lifting tool, motor 3HAC 14586-1
Lifting tool, gear ax.2 3HAC 023240-001
Lifting tool, frame 3HAC 023308-001
Lifting tool, complete robot 3HAC 15607-1
Lifting tool, parallel arm 3HAC 023098-001
Lifting tool, turning device gearbox ax.1 3HAC 14406-1
Lifting tool, base 3HAC 14868-1
Guide pin, (short) 3HAC 7601-086
Guide pin, (long) 3HAC 7601-087
Continued
Continues on next page
To Next Page
Loading...
