NoteAction
xx1200000959
Inspect the oil level at the oil fill/level hole
(level plug).
6
Required oil level is: 0 - 10 mm below the
oil plug hole.
More information is found in Inspecting the
oil level in axis-5 gearbox on page 131.
Tightening torque: 24 NmRefit the oil plug.7
DANGER
Make sure all safety requirements are met
when performing the first test run. These
are further detailed in the section First test
run may cause injury or damage on
page 26.
8
Product manual - IRB 6700 183
3HAC044266-001 Revision: N
© Copyright 2013 - 2018 ABB. All rights reserved.
3 Maintenance
3.4.6 Changing oil, axis-5 gearbox
Continued
To Next Page
Loading...
