3.3.14 Inspecting the dampers
Location of dampers
The figure below shows the location of all the dampers to be inspected.
Axis-2 damper, 2 pcsA
Axis-3 damper, 2 pcsB
Required equipment
Visual inspection, no tools are required.
Inspecting, dampers
The procedure below details how to inspect the dampers.
Note
A damaged damper must be replaced.
NoteAction
DANGER
Turn off all:
• electric power supply to the robot
• hydraulic pressure supply to the robot
• air pressure supply to the robot
Before entering the robot working area.
1
Continues on next page
152 Product manual - IRB 6700
3HAC044266-001 Revision: N
© Copyright 2013 - 2018 ABB. All rights reserved.
3 Maintenance
3.3.14 Inspecting the dampers
To Next Page
Loading...
