Bolt (4 pcs)F
Pin, attached to the fix plateG
Required equipment
NoteArticle numberEquipment, etc.
To be used with the press tool.3HAC11731-1Hydraulic cylinder
To be used with the hydraulic cylinder.3HAC13086-1Hydraulic pump 80 MPa
Content is defined in section Standard
toolkit on page 829.
-Standard toolkit
Consumables
NoteArt. no.Equipment, etc.
Loctite 577-Flange sealant for conical
fittings
Used to secure the attachment screws
of the rear cover at the end of the bal-
ancing device.
Restoring the balancing device
The procedure below details how to restore the balancing device, that is removing
the press tool.
NoteAction
xx0200000174
Press blockA
Hydraulic cylinderB
Press deviceC
Bolt, press deviceD
Moving pin with markingE
Bolt (4 pcs)F
Pin, attached to the fix plateG
Refit the hydraulic cylinder to the press
tool, in case it has been removed.
1
Press with the cylinder and the hydraulic
pump until the fix plate is movable again.
Turn the pin on the fix plate to position
"Open".
CAUTION
Do not apply more pressure than neces-
sary, it could damage bearings and seal-
ings at the shaft.
2
Unload the hydraulic cylinder and make
sure the moving pin indicates that the tool
has returned to its starting position.
3
Remove the hydraulic cylinder.4
Remove the press tool by unscrewing the
bolts.
5
Continues on next page
Product manual - IRB 6700 497
3HAC044266-001 Revision: N
© Copyright 2013 - 2018 ABB. All rights reserved.
4 Repair
4.6.5 Restoring the balancing device
Continued
To Next Page
Loading...
