NoteAction
Disconnect the 24 VDC power supply.10
Refitting the axis-1 motor
These procedures describes how to refit the motor.
Preparations prior to refitting motor
NoteAction
DANGER
Make sure that all supplies for electrical power,
hydraulic pressure, and air pressure are turned
off.
1
Remove any old paint residues or other contam-
ination from the contact surfaces on both the
motor and the mating parts.
2
Wipe clean the contact surfaces and the o-ring
groove.
O-ring, 3HAB3772-107
xx1200001019
Check the o-ring.
Replace if damaged.
3
xx1200001020
Make sure the o-ring is seated in the groove.
Tip
Lubricate the o-ring with some grease for a better
fitting in the groove.
4
Continues on next page
510 Product manual - IRB 6700
3HAC044266-001 Revision: N
© Copyright 2013 - 2018 ABB. All rights reserved.
4 Repair
4.7.1 Replacing the axis-1 motor
Continued
To Next Page
Loading...
