NoteAction
Press tool J included in tool set Dismantle
and mounting tool: 3HAC028920-001
Put the radial sealing on the Press tool J.
Note
Make sure that the sealing is turned accord-
ing to the figure.
3
xx2200001497
xx2200001498
Use a plastic mallet or similar on the Press
tool J and refit the radial sealing.
4
Apply some grease on the surface for the
bearing.
5
Continues on next page
212 Product manual - IRB 6710
3HAC085695-001 Revision: A
© Copyright 2023 ABB. All rights reserved.
5 Repair
5.3.2 Replacing spherical roller bearing, balancing device link ear
Continued
To Next Page
Loading...
