4.4.3 Changing the oil in axis-2 gearbox
Location of the gearbox and oil plugs
The gearbox and its oil plugs are located as shown in the figure.
xx2200001760
Oil plug with nipple for draining and filling with an oil dispenserA
Oil plug hole for inspectionB
Oil plug hole for ventilationC
Required tools and equipment
NoteArticle numberEquipment
The capacity of the vessel must
be sufficient to take the complete
amount of oil.
-Oil collecting vessel
One example of oil dispenser can
be found in section Type of lubric-
ation in gearboxes on page 136.
-Oil dispenser
Content is defined in section
Standard toolkit on page 628.
-Standard toolkit
Required consumables and wear parts
NoteArticle numberWear part
See Type of lubrication in gearboxes
on page 136.
-Lubricating oil
Used on oil plug. Always replace when
refitting oil plug.
3HAC061327-059O-ring, G 1/2"
Continues on next page
144 Product manual - IRB 6710
3HAC085695-001 Revision: A
© Copyright 2023 ABB. All rights reserved.
4 Maintenance
4.4.3 Changing the oil in axis-2 gearbox
To Next Page
Loading...
Need help?
General