NoteAction
Rotation tool M4: 3HAB7887-1Apply the rotation tool.6
Use caution and fit the motor in its final
position while at the same time rotating the
motor pinion slightly using the rotation tool.
• Make sure that the motor pinion is
properly mated to the gear of the
gearbox.
• Make sure that the motor pinion
does not get damaged.
• Make sure that the direction of the
cable exit is facing the correct way.
Hex socket head cap screw: M10x30 12.9
Gleitmo 603+Geomet 500 (2 pcs)
Fit two of the attachment screws and
washers.
7
Bits extender: 3HAC12342-1Use a bits extender in order to reach the
screws.
xx2100002152
Hex socket head cap screw: M10x30 12.9
Gleitmo 603+Geomet 500 (2 pcs)
Remove the guide pins and replace with
the remaining attachment screws.
8
xx2100002153
Tightening torque: 50 Nm.Tighten the screws.9
Disconnect the brake release tool.10
See Performing a leak-down test on
page 178.
Perform a leak-down test.11
Connecting the motor cables
NoteAction
Put the motor cables in place in the open-
ing.
1
Continues on next page
388 Product manual - IRB 6710
3HAC085695-001 Revision: A
© Copyright 2023 ABB. All rights reserved.
5 Repair
5.7.3 Replacing the axis-3 motor
Continued
To Next Page
Loading...
