Removing the axis-1 gearbox
NoteAction
xx2200001408
Remove the attachment screws and washers
that secure the gearbox to the base.
1
Guide pin, M12x200: 3HAC13056-3Fit two guide pins in opposite holes.
Tip
Lubricate the guide pins with some grease
to make the gearbox slide better.
2
Always use guide pins in pairs.
xx2200001409
Lifting eye: 3HAC16131-1Fit two lifting eyes manually in opposite holes
in the gearbox.
CAUTION
Leave a couple of millimeters of space
between the lifting accessory and the surface
of the gearbox. This is done in order not to
damage the surface of the gearbox which is
a sealing surface.
3
xx2200001410
CAUTION
The weight of the gearbox is 85 kg
All lifting accessories used must be sized
accordingly.
4
Continues on next page
450 Product manual - IRB 6710
3HAC085695-001 Revision: A
© Copyright 2023 ABB. All rights reserved.
5 Repair
5.8.1 Replacing the axis-1 gearbox
Continued
To Next Page
Loading...
