NoteAction
Screws: M12x40 12.9 Gleitmo 603+Geomet
500 (39 pcs)
Fit all now accessible attachment screws
and washers.
7
xx2000000459
Screws: M12x40 12.9 Gleitmo 603+Geomet
500
Remove the two guide pins and replace
with the remaining attachment screws and
washers.
8
xx2000000458
Tightening torque: standard torque 120 Nm
(Tightening torque for lubricated screws
(Molykote, Gleitmo or equivalent) with allen
head screws on page 626).
Tighten the attachment screws.9
Remove the lifting accessories.10
Preparations prior to refitting motor
NoteAction
DANGER
Make sure that all supplies for electrical power,
hydraulic pressure, and air pressure are turned
off.
1
Cleaning agent: Loctite 7200, Loc-
tite 7063
Remove any old paint or flange sealant residues
or other contamination from the contact surfaces
on both the motor and the mating parts.
Tip
Remove flange sealant residues with Loctite 7200.
Then use Loctite 7063 for cleaning the mating
surface.
2
Continues on next page
504 Product manual - IRB 6710
3HAC085695-001 Revision: A
© Copyright 2023 ABB. All rights reserved.
5 Repair
5.8.2 Replacing the axis-2 gearbox
Continued
To Next Page
Loading...
