ABB IRB 6710 - Page 600

Spare parts
When calibration is not being performed, a protective cover and an o-ring should
always be installed on the fixed calibration pin as well as a protective plug, included
a sealing, in the bushing. Replace damaged parts with new.
NoteArticle numberSpare part
Contains replacement calibration
pin covers and protective plugs
for the bushings.
3HAC064875-001
(axes 1, 2, 3 and 4)
3HAC059487-001
(axes 5 and 6)
Protection cover and plug set
600 Product manual - IRB 6710
3HAC085695-001 Revision: A
© Copyright 2023 ABB. All rights reserved.
6 Calibration
6.4.3 Installation locations for the calibration tools
Continued