3 Maintenance
3.4.6. Oil change, gearbox, axis 5
2133HAC022033-001 Revision: K
© Copyright 2004-2011 ABB. All rights reserved.
Required equipment
NOTE!
The specified amount of oil is based on the total volume of the gearbox. When changing the
oil, the amount of refilled oil may differ from the specified amount, depending on how much
oil has previously been drained from the gearbox.
Draining, oil, gearbox axis 5
The procedure below details how to drain the oil from the gearbox, axis 5.
When using the oil exchange equipment, follow the instructions enclosed with the kit. Art.
no. for the kit is specified in Required equipment on page 213.
Equipment, etc. Art. no. Amount Note
Lubricating oil 3HAC032140-001 750 ml Kyodo Yushi TMO 150
To be used in the primary gearbox.
Lubricating oil 3HAC032140-001 3,800 ml Kyodo Yushi TMO 150
To be used in the secondary
gearbox.
Oil collecting vessel Capacity: 1,000 ml.
Oil collecting vessel Capacity: 4,000 ml.
Oil exchange
equipment
3HAC17313-1 Content is defined in section
Special tools on page 428.
Standard toolkit - Content is defined in section
Standard toolkit on page 427.
Action Note
1.
WARNING!
Handling gearbox oil involves several safety risks.
Before proceeding, please read the safety
information in the section WARNING - Safety risks
during work with gearbox lubricants (oil or grease) on
page 51.
2. Open the oil plug, draining, primary gearbox.
3. Drain the oil from the primary gearbox. Vessel capacity: 1,000 ml.
4. Run axis 4 to a position +90° from the calibration
position.
5. Open the oil plug, draining, secondary gearbox. Shown in the figure Location of
gearbox on page 212.
6. Drain the oil from the secondary gear. Vessel capacity: 4,000 ml.
7. Refit the both oil plugs, draining. Shown in the figure Location of
gearbox on page 212.
Tightening torque: 24 Nm.
Continued
Continues on next page
To Next Page
Loading...
