4 Repair
4.6.3. Replacement of motor, axis 3
3HAC022033-001 Revision: K346
© Copyright 2004-2011 ABB. All rights reserved.
Replacement of the motor axis 3 (Foundry Prime)
Robots working with Foundry Prime and that have the special tightness for this application
require special repair routines to maintain the tightness level.
The repair must be done according to the previous repair procedures with the following
additions.
20.
DANGER!
Make sure all safety requirements are met when
performing the first test run. These are further
detailed in the section DANGER - First test run
may cause injury or damage! on page 47.
Action Note
Action Note
1.
DANGER!
Turn off all electric power, hydraulic and
pneumatic pressure supplies to the robot!
Turn off all electric power and hydraulic but not the
air pressure to the gearboxes, motors and SMB.
2. Remove the motor according to step 2 - 4 in
Removal, motor on page 343.
3. Remove the cover for connector access on top of
the motor by unscrewing its four attachment
screws.
xx0600002874
• A: Attachment screw
• B: Air hose
• C: Top cover
• D: Motor unit
Continued
Continues on next page
To Next Page
Loading...
