ABB REG316 4 Series - Installing SMS010 and Reporting and SM;RE.316*4 for SMS010; Sms010

ABB Switzerland Ltd REG 316*4 1MRB520049-Uen / Rev. E
5-124
5.14. SMS010
5.14.1. Installing SMS010 and ‘Reporting’ and ‘SM/RE.316*4’ for
SMS010
Installation sequence
1. Install SMS010.
2. Install ‘Reporting’ for SMS010.
3. Install ‘RE.316*4’ for SMS010.
SMS010 must be installed before attempting to install ‘Reporting’
and ‘RE.316*4’, otherwise they cannot be installed.
The SMS010 installation program is on SMS Base, Disc 1. The
installation program creates all the directories needed and cop-
ies all the files to the hard disc. Program examples are to be
found on Disc 2.
The ‘Reporting’ installation program is on Reporting Program,
Disc 1. The installation program creates all the directories
needed and copies all the files to the hard disc. Program exam-
ples are to be found on Disc 2.
The ‘HMI RE-316*4 for SMS010’ installation program is on
SM/RE.316, Disc 1. The installation program creates all the di-
rectories needed and copies all the files to the hard disc. If
SMS010 is not in the default directory, a request appears to en-
ter the directory where SMS010 is located. The program must be
installed from a floppy drive.
The following files are copied to the hard disc:
· RE_316#4.EXE is copied to the directory
\SMS010\Base\Support\, providing \SMS010\Base was the di-
rectory created when installing SMS010.
· The directory REC316 is created in \SMS010\Base\Modules.
· Files Rec316.CNF, Rec316.DEF and Rec316.SUP are copied
to the directory \SMS010\Base\Modules\REC316.
· The file devices in directory \SMS010\Base\Modules are up-
dated.