ABB REG316 4 Series - Starting and Shutting down the Operator Program

REG 316*4 1MRB520049-Uen / Rev. E ABB Switzerland Ltd
5-9
5.2.3. Starting and shutting down the operator program
To start the operator program click on the icon created during
the installation procedure.
The corresponding sequence can be seen from the flow chart
below (Fig. 5.1). The program starts in the off-line mode or with a
new (“empty”) relay as REC 316*4. The choice of relay type and
the main configuration parameters can be entered or edited by
selecting the menu item ‘Edit hardware functions’.
Start program
Relay
connected?
Relay not
connected.
Continue off-line?
<Y> / <N>
LOAD...
settings
TEST...
system
Main menu
Main menu
Are you sure?
<Y> / <N>
(ON-LINE)(OFF-LINE)
Close program
ABB logo
Y
Y
Y
N
N
N
BACKBACK
<Enter>
<Esc>
Fig. 5.1 Flow chart of the operator program start-up and shut-
down sequence