ABB REG316 4 Series - Menu Item Create New DSC Files

ABB Switzerland Ltd REG 316*4 1MRB520049-Uen / Rev. E
5-130
Keys:
· Page Up Þ previous page.
· Page Down Þ next page.
· Arrow key Þone line up.
· Arrow key ¯Þone line down.
· Space bar Þ for editing settings.
· F1 Þ help.
· ESC Þ for terminating the program. If changes
were made, your are requested to con-
firm that they should be saved.
5.14.4.3. Menu item ‘Create New DSC Files’
This menu item is for creating the files needed from the pa-
rameter list of the particular device the first time the HMI is
started. It is also needed every time the device parameter set-
tings are changed.
In the off-line mode, a parameter file must be downloaded first
using the editor’s ‘Load from file’ function, since the ‘Create new
DSC files’ function requires the currently active set of parameter
settings.
The following files are created:
· Event.DSC Þ event handling file for ‘Reporting’
· Logging.DSC Þ logging window file for ‘Reporting’
· Channel.DSC Þ file with the function designations
· Functyp.DSC Þ required for updating files.