GUID-96ECAC44-6A11-4C1F-B50C-3E8A80051950 V1 EN
Figure 12: Technical key information
2. Click OK.
The technical key is read from the IED and the Set Technical Key dialog box opens.
GUID-177E6088-50E3-4A18-83E6-9777AEACB3C1 V1 EN
Figure 13: Setting the technical key
3. In Set Technical Key dialog box, select the technical key to be used. There are three
alternatives.
• Use the existing technical key in the IED
• Use the existing technical key defined for the IED object in PCM600
• Set a user-defined technical key, which changes the technical key for both the
physical IED and IED object in PCM600
4. Click OK to confirm the selection.
It is not possible to set a user-defined name or select the Technical
key in IED if the value is the same as already given to another IED
object in the PCM600 project. An error message is displayed if this
happens.
1MAC108982-MB E Section 3
PCM600 tool
615 series ANSI 37
Engineering Manual
To Next Page
Loading...
