EasyManuals Logo

ABB RET670 Commissioning Manual

ABB RET670
328 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #24 background imageLoading...
Page #24 background image
the character ^ in front of an input/output signal name indicates that the signal
name may be customized using the PCM600 software.
the character * after an input signal name indicates that the signal must be
connected to another function block in the application configuration to achieve
a valid application configuration.
Logic diagrams describe the signal logic inside the function block and are bordered
by dashed lines.
Signals in frames with a shaded area on their right hand side represent setting
parameter signals that are only settable via the PST, ECT or LHMI.
If an internal signal path cannot be drawn with a continuous line, the suffix -int
is added to the signal name to indicate where the signal starts and continues.
Signal paths that extend beyond the logic diagram and continue in another
diagram have the suffix ”-cont.”
Dimensions are provided both in inches and millimeters. If it is not specifically
mentioned then the dimension is in millimeters.
Illustrations are used as an example and might show other products than
the one the manual describes. The example that is illustrated is still valid.
1.5 IEC 61850 edition 1 / edition 2 mapping
Function block names are used in ACT and PST to identify functions. Respective
function block names of Edition 1 logical nodes and Edition 2 logical nodes are shown in
the table below.
Table 1: IEC 61850 edition 1 / edition 2 mapping
Function block name
Edition 1 logical nodes Edition 2 logical nodes
AEGPVOC AEGGAPC AEGPVOC
AGSAL AGSAL
SECLLN0
AGSAL
ALMCALH ALMCALH ALMCALH
ALTIM - ALTIM
ALTMS - ALTMS
ALTRK - ALTRK
BCZPDIF BCZPDIF BCZPDIF
BCZSPDIF BCZSPDIF BCZSPDIF
BCZTPDIF BCZTPDIF BCZTPDIF
Table continues on next page
Section 1 1MRK 504 165-UUS -
Introduction
18 Transformer protection RET670 2.2 ANSI
Commissioning manual

Table of Contents

Other manuals for ABB RET670

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the ABB RET670 and is the answer not in the manual?

ABB RET670 Specifications

General IconGeneral
Rated Frequency50/60 Hz
InputsAnalog and binary inputs
ApplicationProtection of power systems
Communication ProtocolsIEC 61850, DNP3, Modbus
Operating Temperature Range-25°C to +55°C
MountingRack mounted
Number of Binary InputsUp to 48
Number of Binary Outputs32
Protection FunctionsOvercurrent Protection
OutputsBinary outputs
EnclosureIP 54
TypeLine Differential Protection
Number of Analog Inputs24

Related product manuals