EasyManuals Logo

ABB RET670 Commissioning Manual

ABB RET670
328 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #37 background imageLoading...
Page #37 background image
The IED with accessories should be mounted in a cubicle in a restricted
access area within a power station, substation or industrial or retail
environment.
2.3 Caution signs
Whenever changes are made in the IED, measures should be taken to
avoid inadvertent tripping.
The IED contains components which are sensitive to electrostatic
discharge. ESD precautions shall always be observed prior to touching
components.
Always transport PCBs (modules) using certified conductive bags.
Do not connect live wires to the IED. Internal circuitry may be damaged
Always use a conductive wrist strap connected to protective ground when
replacing modules. Electrostatic discharge (ESD) may damage the
module and IED circuitry.
Take care to avoid electrical shock during installation and
commissioning.
Changing the active setting group will inevitably change the IEDs
operation. Be careful and check regulations before making the change.
1MRK 504 165-UUS - Section 2
Safety information
Transformer protection RET670 2.2 ANSI 31
Commissioning manual

Table of Contents

Other manuals for ABB RET670

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the ABB RET670 and is the answer not in the manual?

ABB RET670 Specifications

General IconGeneral
Rated Frequency50/60 Hz
InputsAnalog and binary inputs
ApplicationProtection of power systems
Communication ProtocolsIEC 61850, DNP3, Modbus
Operating Temperature Range-25°C to +55°C
MountingRack mounted
Number of Binary InputsUp to 48
Number of Binary Outputs32
Protection FunctionsOvercurrent Protection
OutputsBinary outputs
EnclosureIP 54
TypeLine Differential Protection
Number of Analog Inputs24

Related product manuals