3-16
Questions? Refer to Page 11-22 For Technical Support Instructions.
Chapter 3: Patient Test
What You See on the Display What You Do Comments
3. Press Scan to scan the Operator ID
barcode or manually enter the Operator
ID via the keypad, then press Enter.
While the Operator ID may be up to 30
digits, not all digits will fit on the display.
The meter may also be set to truncate
(ignore) leading, trailing, and/or selected
digits of the barcode.
4. Press Scan to scan the Patient ID
barcode or manually enter the Patient
ID via the keypad (if enabled).
While the Patient ID may be up to 30 digits,
not all digits will fit on the display. The
meter may also be set to truncate (ignore)
selected digits of the barcode.
5. Confirm the Patient ID (if prompted).
You may see one of the following four
screens:
Re-enter the ID using the keypad.
If you enter the ID manually, you may be
required to enter it a second time to ensure
it is correct.
To Next Page
Loading...
