4-5
Questions? Refer to Page 11-22 For Technical Support Instructions.
What You See on the Display What You Do Comments
3. Press Scan to scan the Operator ID
barcode or manually enter the Operator
ID via the keypad, then press Enter.
While the Operator ID may be up to 30
digits, not all digits will fit on the display.
The meter may also be set to truncate
(ignore) leading, trailing, and/or selected
digits of the barcode.
4. Scan or manually enter the low control
solution lot number via the keypad,
then press Enter.
You can scan or manually enter the
information from the control solution’s
barcode. For manual entry, key in the five
numeric digits of the lot number printed on
the control solution bottle. You do not need
to enter the alpha character that appears at
the end of the 5-digit number. The Strip Lot
screen will appear next.
Chapter 4: Control Test
To Next Page
Loading...
