5-2
Questions? Refer to Page 11-22 For Technical Support Instructions.
Follow these steps to access the Data Review menu:
What You See on the Display What You Do Comments
1. Press the On/Off button to turn the
meter on.
The Abbott logo screen will appear in
black for a few seconds and then will
appear in grey to ensure that the display is
functioning properly. Next, the software
version will briefly appear.
2. Press the Menu button. The meter starts in Test Mode. The Menu
button will toggle the meter to Menu
Mode.
Note: The following section illustrates some common settings. Depending on your facility’s specific settings,
some screens will display differently or not at all. If the meter does not display the screens shown,
please refer to Chapter 11, Troubleshooting.
Chapter 5: Data Review
To Next Page
Loading...
