Acer 6000 - LS-120 Drive as

Chapter 3 - BIOS Utility 3-9
•
[720 KB, 3.5-inch]
•
[1.44 MB, 3.5-inch]
•
[2.88 MB, 3.5-inch]
Follow the same procedure to configure floppy drive B. Choose
None
if you do not
have a second floppy drive.
3.4.2 LS-120 drive as
This parameter allows you not only to enable the LS-120 device installed in your
system, but also to specify the function of the device. The setting affects how BIOS
will detect the device.
Possible settings are:
•
Normal
In this setting, BIOS does not support the LS-120 drive. The drive
needs the LS-120 device driver to operate.
•
Drive A
BIOS recognizes the LS-120 drive as drive A. If a standard diskette
drive A exists, BIOS automatically identifies it as drive B. If a standard
diskette drive B exists, it automatically becomes inaccessible.
If two LS-120 drives exist, BIOS recognizes them as drive A and drive B,
respectively.
•
Drive B
BIOS recognizes the LS-120 drive as drive B. If a standard diskette
drive B exists, it becomes inaccessible.
•
Hard Disk
BIOS recognizes the LS-120 drive as a hard disk. In this setting,
format the LS-120 drive as any other hard disk and assign it a drive letter C, D,
E, and so on. See the documentation that came with the LS-120 drive for more
information.