Chapter 3 - BIOS Utility 3-19
3.6 Power Management
The Power Management menu lets you configure the system power-management
feature.
The following screen shows the Power Management parameters and their default
settings:
Power Management Page 1/1
Power Management Mode .............. [Enabled ]
IDE Hard Disk Standby Timer ...... [10] Minute(s)
System Sleep Timer ............... [10] Minute(s)
Sleep Mode ..................... [Suspend]
Power Switch < 4 Sec. ............... [Suspend ]
System Wake-Up Event
Modem Ring Indicator .............. [Disabled]
↑↓ = Move Highlight Bar F1 = Help
Esc = Exit → ← = Change Setting,
3.6.1 Power Management Mode
This parameter allows you to reduce power consumption. When this parameter is
set to
Enabled
, you can configure the IDE hard disk and system timers. Setting it
to
Disabled
deactivates the power-management feature and its timers.
IDE Hard Disk Standby Timer
This parameter allows the hard disk to enter standby mode after inactivity of 1 to
15 minutes, depending on your setting. When you access the hard disk again,
To Next Page
Loading...
