3-56 Machine Maintenance Procedures
3. Starting from the bottom-center of the bezel (Figure 3-61), separate the bezel upwards
and away from the panel. Move along the edge until the bezel is completely removed.
Figure 3-61. LCD Bezel Removal
LCD Bezel Installation 0
1. Locate the bezel hinges (B) on LCD cover (Figure 3-61).
2. Press down until there are no gaps between the bezel and the LCD module cover hinge
wells.
Make sure that the LCD cables pass through the hinge wells and are not trapped by the
bezel.
3. Press the entire perimeter of the bezel until there are no gaps between the bezel and the
LCD module.
4. Install the two (2) screws (B) and mylar covers to secure the LCD bezel (Figure 3-59).
5. Install LCD Module.
ID Size Quantity Screw Type
B M2.5x4.0 2
SG_JV51_HR.book Page 56 Friday, July 8, 2011 5:58 PM
To Next Page
Loading...
