5-10 Jumper and Connector Locations
BIOS Recovery by Crisis Disk 0
BIOS Recovery Boot Block 0
The BIOS Recovery Boot Block is a special block of BIOS. It is used to boot up the system
with minimum BIOS initialization. Users can enable this feature to restore the BIOS firmware if
a previous BIOS flashing process has failed.
BIOS Recovery Hotkey 0
To enable the BIOS Recovery process, use the function hotkey, <Fn+Esc>, during BIOS
POST. The AC adapter and battery are required to be installed during this process.
SG_JV51_HR.book Page 10 Friday, July 8, 2011 5:58 PM
To Next Page
Loading...
