Load Contrast
36 | English (USA) 2019-08 901418-003,01 ACIST | CVi® System User's Guide
4 Setup
7. Place the tubing in the contrast sensor and securely close the sensor latch.
8. Place the contrast container onto the hanger. Verify the white slide clamp
is open and above the contrast sensor.
Important
• Make sure the contrast spike tubing is completely secured in the contrast
sensor, and that the latch on the contrast sensor is fully closed. If the
contrast spike tubing is not properly secured in the contrast sensor, the
system may produce an error stating No contrast.
• If the air vent and the white slide clamp are not open, the system may
produce an error stating No contrast.
To Next Page
Loading...
