7
The door can be opened:
1. With the “key” button on receiver in the apartment
The door will open upon pressing the opening button ("key") on the receiver.
Typically, the door can be opened only during connection (conversation). During
one connection the door can opened three times (that together with enabling the
second output - F2), after which the connection will terminate automatically (the
parameter can be set to: 1, 2 or 3). The door can also be opened without having
to connect with the apartment - refer to the I/O module settings in the computer
program for details. In this case, on classic uniphones the handset must be
picked up and the open button pressed three times, on active receivers (INS-
UP720MR, UP800/MP800, INS-MPx) the open button must be pressed once.
2. With user’s access code
Use the keypad to select the apartment number to which the code is assigned,
confirm with the "key" button and enter the four-digit code. The code is unique
for each apartment and can be easily changed. Access codes are pre-set by the
manufacturer as a code table. Each table has its unique 4-digit number, used to
generate 255 different access codes for residents. INSPIRO+ supports up to 4
different code tables, thus making it possible to use 1020 different codes.
Full table with residents’ codes or residents’ name tags together with use
instruction can be printed using the "ACO Code Generator" available at
www.aco.com.pl - user zone (“download"). A name tag may include a logo and
one line of text for company name and phone number etc..
In Master panels the code table is entered at the factory as a 4-digit number at
the back of the unit; the same table must then be entered in Slave panels. The
installer can check (in P1 program) the current value of each code and change it
if necessary.
For the code table number "9999" opening with a user’s code is disabled.
Access codes may also be changed by the users (this function must be activated
using the computer program: “Code change activation"). To change the code,
press the "key" button during the first seconds of door opening (as the "Enter"
sign is displayed). The unit will switch to code change mode (it will display
“OpenCode”); enter the new code when "----" is displayed, then enter the new
code again when prompted by the "Repeat" message. Successful code change
will be confirmed by "Done” on the display. The code change process can be
cancelled by pressing the "#" key.
3. With proximity card or key fob
Units with the ACC proximity reader can be used with proximity card or key fob
(resident’s or administrator/installer’s), programmed in the unit. A card or key
fob which is not programmed will generate a “beep” sound twice.
4. With administrator’s access code
To get access using the administrator’s code, press the "key" button on the
keypad and then enter the six-digit administrator’s code (it can be modified to a
To Next Page
Loading...
