Chapter 15: Managing Controllers and Disk Drives ● 145
Replacing Disk Drives in a Logical Drive
You can replace one or more disk drives in a logical drive. You may want
to do this to upgrade to larger disk drives, or to make disk drive size
uniform across the logical drive.
Caution: If another disk drive in the logical drive fails during
rebuild (see page 151), you may lose data.
To replace a disk drive in a logical drive:
1 In the Physical Devices View, click the disk drive you want to replace.
2 Set the drive state to failed. (See page 144.)
3 Remove and replace the disk drive with one of equal or larger size.
4 Wait for the logical drive to rebuild. (See page 151.)
5 Repeat Steps 1 to 4 for all the disk drives you want to replace.
For information about solving disk drive problems, see Recovering from
a Disk Drive Failure on page 147.
To Next Page
Loading...
