Additel 761A - 5.4.3 Aneroid barometer

122
4. Task start
For the contents, refer to Section 5.2.1 Task start for calibration of the analog pressure gauge.
5. Task end
For the contents, refer to Section 5.2.1 Task end for calibration of the analog pressure gauge.
5.4.3 Aneroid barometer
1. Connection
 Connect the calibrator and the mercury barometer as shown in Figure 5-9:
2. New task
Select the “aneroid barometer” in the test type list. The other contents are the same as those in
Section 5.2.1 New Task for Calibration of the analog pressure gauge.
3. Task setting
For the contents, refer to Section 5.2.1 Task setting for calibration of the analog pressure gauge.
4. Task start
For the contents, refer to Section 5.2.1 Task start for calibration of the analog pressure gauge.
5. Task end
For the contents, refer to Section 5.2.1 Task end for calibration of the analog pressure gauge.