83
display or table display.
Pressure switch action: When the internal pressure module is used as the standard, it will be
automatically run the test. When the external pressure module is used as the standard manual
pressure generation is required and the switch data will be recorded.
To stop this test, click the back button .
3. Save the result
Click the save button to save the test result.
The following items need to be entered: Name and serial number, click OK button to save the
test results.
To exit without saving press the back button .
To redo the test click the reset button .
5.1.4 Pressure sensor
Select the “pressure sensor” icon in the test type list to start the quick test.
1. Connection
Connect the sensor as shown in Figure 5-2.
2. Start the test
Same as Section 5.1.2 Pressure transmitter.
3. Save the result
To Next Page
Loading...
