Additel 761A - 2.3 Getting started; 2.3.1 Power on; 2.3.2 Setting the system date and time; 2.3.3 Generating a pressure

18
2.2.3 View the display
Push the front lock to the right and raise the touchscreen to the proper position
2.3 Getting started
2.3.1 Power on
◆ Press to turn the power on.
◆ The startup screen shows the manufacturer's logo.
◆ After a short time the system enables the home screen.
◆ Connect the power supply for charging if power is low.
◆ If calibrator is charging, the touchscreen will dim, press turn it on.
2.3.2 Setting the system date and time
◆ Refer to section 4.6.1 to set date and time
2.3.3 Generating a pressure
At the home screen, enter the desired pressure value using the numeric keypad, press enter and calibrator will
generate and control to the target pressure (see section 3.2.1)