65
brightness will be automatically set to the lowest value.
There are six settings to choose from: never, 30 sec, 1 min, 5 min, 15 min, and 30 min.
When the backlight is turned off, the first key-press will resume the backlight brightness, only after
which subsequent key-pressing can take effect normally.
During pressure control, auto-step or task execution, this function does not take effect.
2. Auto sleep
In case there is no key and serial port command operation within a set time, it will automatically
sleep.
There are four auto-sleep settings: never, 1 min, 5 min and 30 min.
If connected to a power adapter, the calibrator does not support auto-sleep.
During pressure control, auto-step or task execution, this function does not take effect.
When the backlight off time is set to "never", the auto-sleep setting is invalid.
3. Auto power off
In case there is no key and serial port command operations within a set time, it will automatically
shut down.
There are five auto power off settings: never, 5 min, 15 min, 30 min, 1 hour and 2 hours.
If connected to a power adapter, the calibrator does not support auto power off.
During pressure control, auto-step or task execution, this function does not take effect.
When the backlight off time or auto sleep time is set to "never", the setting of auto power off is
invalid.
To Next Page
Loading...
