aditec MIC 3000 - Standby; Program Groups and Program Images in Standby

User Manual MIC 900 / MIC 1100 / MIC 3000
12
Issue 17.08.2021_00
2 Standby
As soon as the controller has been connected to a power supply, it will automatically boot up and will
display the message „Loading please wait...“. This process can take up to 1 minute. Then you will get
to the standby screen.
Be aware
Please do not operate the touch screen with sharp implements i.e. pointed fingernails,
pens/pencils, screwdrivers etc. Only use blunt, soft implements i.e. fingers, rubber pens.
Current Program bar
Pr.group Step bar
Current Optional
Pr.image displays
(menu of favourites)
Actual value display
Symbols | Scale
Select program group
Status bar
System time
Task bar
In standby none of the programs has been selected, this means that nominal values are not displayed.
The current operating status of the installation is shown on the information bar.
2.1 Program groups and program images in standby
Hint
Program images/program groups are only displayed when the option is enabled. Ask your
service technician.
• Current program image: The current program is displayed (display only).