• Current program proup:
The current program group (related to the current program) is
displayed. By touching the field, all programs belonging to this
program group are displayed and can be selected.
• Program group selection:
All 12 program groups are displayed. By touching the program
group, all programs belonging to this group are displayed and can
be selected.
Display of all programs which are not assigned to a program group:
Select program 00 → Touch the field current program group → all programs are displayed
which are not assigned to a program group
2.2 Selecting a program
Starting from standby mode, you have 3 options of how to select a program:
2.2.1 Program number:
Use the numerical pad to enter the program number
and confirm with „Enter“.
2.2.2 Program name
A menu list of all available programs will open. Select
the program you want and confirm with „Enter“.
2.2.3 Favourites list
Press on the program you want on the favourites list.
You can find information on how to set up a favourites list,
item 4.2
Setting up a favourites list, page 22.
2.3 Selecting a step
In standby you can select steps. This allows you to skip steps during operation or to repeat a step that
has already run. You can also select a step while in standby mode in order to e.g. check on the
entered nominal values or to start a program with the second or third step.
Starting from standby mode, there are 3 options of how to change steps:
To Next Page
Loading...
