User Manual MIC 900 / MIC 1100 / MIC 3000
4.2 Setting up a favourites list
Select a program form the program list on the left side (see figure “Program selection programming
mode”). Press on one of the lines in the favourites list and the program will be transferred to that
position. Now you have the option of selecting a program from the favourites list on the standby page
and then start it by pressing „Start“.
A program on the favourites list cannot be simply deleted, it can only be overwritten. If
you want to create a blank line in the favourites list, you can overwrite an existing
program with an empty program without program name. Now a blank line will appear on
the favourites list on the standby page.
4.3 Editing program steps
Start on the „Program selection“ display and highlight the program you want to edit by pressing on it.
Now press the „Edit“ button on the task bar. In the next options display also press „Edit”.
Be aware: Changes in operating mode
If the currently running step is changed1 in operating mode, the change is only effective after
the step has been completed.
4.3.1 Display for editing program steps
Program bar (note: program selection, copying programs)
Step bar (note: process selection, copying steps, adding repetitive steps)
Nominal values
(aggregates, step time)
Nominal values (addition: aggregate
modules, analogue outputs…)
Information bar (display: status, repetitive steps)
Task bar (back, one step back, one step forward, menu, start)
Changes can be made on the controller or by sending the current program from VisuNet or from the service program
To Next Page
Loading...
