2.7.3 Editing a program step:
Back: Calling up the start page / standby
Arrow buttons(<, >): Press the arrow buttons right/left to skip forward or backwards from step to step
within a program.
Menü: Press the „Menu“ button to get to the menu page
(see „Menu page“, item 3, page 20)
Start: Starts programs. („Program start“, item 5, page 28)
2.8 Information bar
On the information bar you can see messages, operating status, alarm messages and the system
time.
3 Menu page
The „Menu“ page of the touch panel is arranged as follows:
Menu
▪ Configuration:
System specific controller settings.
The settings are protected by a password and can only be set up by a service technician.
▪ Service:
Settings for the maintenance personnel on-site: Initial start-up, maintenance work etc.
The settings are protected by a password and can only be set up by a service technician.
▪ Profiles:
Settings for the operator/end user.
These settings are not password protected.
▪ Programs:
Opens the program selection page.
To Next Page
Loading...
