Chamber sensor defect generally leads to program termination.
Core- or humidity sensor defect will lead to a termination of the program if the relevant nominal
value has been pre-programmed.
When an alarm event has occurred, for example at a digital input, limit value alarm or sensor break,
the „Step“ box and a loudspeaker symbol will be flashing alternately (Alarm, horn).
On the status bar the alarm and the reason for the alarm will be shown (e.g. sensor break, chamber
temperature). Click on the box to acknowledge the alarm and to de-activate the horn.
6.8 Maximum step time display
(from V00.18)
The maximum step time count ends at 99 h : 59 min. This means that in continuous operation the time
until then is counted. If this time is exceeded, 99 h : 50 min is still displayed.
6.9 Checking cleaning times in the operating mode
During operation, neither the current cleaning sequence nor the individual section times can be
changed. The current cleaning status can be checked.
Operating mode view (values are for
information only and cannot be
changed)
• Currently active string (line is
shown in red)
• Relay assigned in the cleaning
string is switched on "1"
Calculated total time of all sections
Leave cleaning mask
To Next Page
Loading...
