aditec MIC 3000 - Loading Programs; Loading Progams

User Manual MIC 900 / MIC 1100 / MIC 3000
40
Issue 17.08.2021_00
8.5 Loading programs
Loading programs
Be aware: Supporting the USB
The USB interface is only meant to be used to read out/retrieve data logger data and
copy programs from one controller to another via a USB.
Please do not connect any USB periphery devices (key board, mouse, printer) at this
interface.
All common USB mass storage devices in FAT16 and FAT32 format are supported.
NTFS formatted USB mass storage devices and external hard disks are not
supported!
For your information
If no USB storage device is inserted in the controller, the message „No USB storage
connnected!“ will be shown.
If a USB stick is detected, the message „USB storage device found!“ will be shown.
8.5.1 Loading progams
The controller can read out all program from USB:\ProgUSB\Program.adp. Existing programs are
overwritten with new ones.
Be aware
In order to read out program from a USB the file name and path must be exactly:
USB:\ProgUSB\Program.adp.
Administrator rights
This setting is protected by a PIN when administrators are registered. Only users with the
authority to „Set up programs“ have access to this feature.
Restrictions (controller version 00.16)
At this time the following features cannot be read out from program data:
• Air circulation sequence
• Cleaning sequence, time intervals
• Repetitive step sequences