aditec MIC 3000 - Alarm Messages; Optional Control Loops; Measured Values; Favourites; Aggregate Buttons

User Manual MIC 900 / MIC 1100 / MIC 3000
18
Issue 17.08.2021_00
2.6.5 Alarm messages
All digital inputs which have been configured as alarms in a
process or program and their operating status are shown here.
0 – Contact open
1 – Contact closed
2.6.6 Optional control loops / measured values
The installation manufacturer can enable additional control loops
in every individual process. This list shows you the optional control
loops which have been enabled in the current process together
with their actual values.
2.6.7 Favourites
The programs that have been put on the favourites list are shown
in this display. Here you can select a program from the list.
How you can set up your own favourites list is described under„
Setting up a favourites list“ p.22.
2.6.8 Aggregate buttons
In this display a list of the aggregate buttons and their switching
status is shown. Certain relays can be switched on/off by the user
via these aggregate buttons.
2.6.9 Aggregate modules
In this display a list of the aggregate modules is shown. Certain
relays can be switched on/off by the user via these aggregate
buttons.