aditec MIC 3000 - Selection Via the Process Name; Selection Via the Step Number; Using the Task Bar to Switch into the Next Step

User Manual MIC 900 / MIC 1100 / MIC 3000
14
Issue 17.08.2021_00
2.3.1 Selection via the process name
Selecting a process name
Press the box with the process name and a list of all the processes will open. From this list you can
now assign the required process to the step. Please press „Enter“ to confirm your choice.
2.3.2 Selection via the step number
Press the step number box and the on-screen numerical pad will open. Enter the required step
number via the pad and confirm with „Enter“.
Please note
In the step box you can also see current alarm messages (e.g. sensor fault).
2.3.3 Using the task bar to switch into the next step
Task bar
Use the arrow buttons to change into the previous or next step respectively.